AUTONET TV

Such a Little Part (Climate Control Resistor)

You expect your heater/air conditioner to work like it should.  You have a control for temperature and one for fan speed.  You even have a control for what vents the air comes out of. 

Don't be surprised one day if your blower fan develops a mind of its own and starts going crazy.  Most of the time, you may find that it starts blowing at full speed, and nothing you do to try to control it does any good.  This is what may be happening.

Your blower motor has an electronic component called a resistor.  It does what its name says; it offers resistance.  When you want the fan to run more slowly, you turn the fan speed down.  That resistor accomplishes that by turning its resistance up.  When the resistor fails, the power has nothing to slow it and the fan speeds up. 

It's a small part and can fail due to age or corrosion.  It's usually not an expensive part, either, but it's often found in a location that's not that easy for the technician to get to.  That means labor costs will vary depending on the design of your vehicle. 

Occasionally, a faulty resistor can cause the blower motor not to work at all or only partially come on.  But other things can cause that as well, such as a faulty fan switch or vent control. 

This is where a technician's training comes in.  Special equipment can track down precisely where the issue is so you can be assured the correct part is being replaced.

It's just not pleasant when the blower motor isn't following orders.  Have your service facility check it out so you can be the blower's boss, like it should be. 

American Brake Centers Inc.
3435 Bashford Ave Ct.
Louisville, KY 40218
502-459-0355
www.americanbrakecenters.biz

Don't Be Fuelish

If you smell gasoline in your vehicle, pay attention to your nose. That's because it has an important message for you.

Newer vehicles should never have a gasoline smell inside. One of the most dangerous conditions can come when your fuel line system has a leak or multiple leaks. Vehicles with fuel injectors are under pressure, meaning a crack or small hole in a fuel line can allow vaporized fuel to escape, sometimes around hot engine parts. Gasoline vapor and hot metal? You see the problem.

One of the most common causes of a gasoline smell inside a vehicle is a fuel tank leak. The gas tank can rot or be punctured by road debris. A American Brake Centers Inc. technician can evaluate the condition of your fuel tank and suggest either repair or replacement.

Fuel injectors can develop small leaks around their seals or O-rings. Those can deteriorate over time as the material they are made of gets old and less flexible. A technician can replace those parts.

Modern vehicles contain something called a charcoal canister. It gathers evaporating gasoline vapors from inside your fuel tank and prevents them from venting out to the atmosphere. If that canister has a leak, you'll smell it. One hint that you have a problem is the Check Engine light may come on.

You may have a leak in your fuel tank vent hose. Or you may be smelling gasoline simply because your gas cap is loose, the cap is faulty or—yes this does happen—your gas cap is missing altogether.

Consider the dangers of gasoline fumes seriously. Inhaling them can be bad for your health or they may start a fire. Don't fool with fuel; have gasoline odors checked out right away.

American Brake Centers Inc.
3435 Bashford Ave Ct.
Louisville, KY 40218
502-459-0355
www.americanbrakecenters.biz

Why is My Brake Pedal Hard to Push?

When you push on your brake pedal, you should find your vehicle easy to stop.  But at some point, you might notice stopping takes much more pressure on the pedal than it used to.  When it gets to that point it becomes a safety issue, and you should bring your vehicle in so we can track down what’s not working correctly.

Brake pedals that are stiff mean there’s something wrong with one or more components of your entire brake system.  For example, it could be moisture has contaminated your brake fluid, making it harder to push the pedal down.

Many vehicles use hydraulics to amplify your pedal pressure to a force strong enough to stop your vehicle.  Certain problems can develop with your hydraulics, such as a faulty master cylinder, a kink in one of your brake lines, or a failed proportioning valve which regulates pressure to your rear brakes. Vacuum leaks can also make your brake pedal hard to push. Another cause could be a problem with your vehicle’s brake booster or its check valve.

Because your vehicle’s braking system is made up of many different components, one of our technicians will look at several different possible causes in yours.  Your vehicle may not have enough brake fluid in it, so they’ll check the level.  A visual inspection of your hoses, brake lines and vacuum line to the brake booster may turn up the root cause of your issues.   

Because there are many different causes of a hard-to-push brake pedal, solutions may involve one or more different steps.  Keep in mind this is one problem that needs to be fixed for you to drive safely.  That’s why it’s important to have a professional track down the issue, or issues, and take care of the problem(s) so you can be back on the road, safely going and stopping.

American Brake Centers Inc.
3435 Bashford Ave Ct.
Louisville, KY 40218
502-459-0355
www.americanbrakecenters.biz

Full of Hot Air (Air Conditioning)

In warm weather, you want to be in a cool vehicle. When we're talking cool, we don't mean stylish or trendy, but cool as in not sweltering inside.  And if your vehicle's air conditioner stops working correctly, it seems to always break at the worst time—during a heat wave. 

Automotive air conditioning problems fail for a number of reasons:

• Blower motor not working.  No air comes through the vents, even though the rest of the system could be working fine.
• Refrigerant leak. When the gas that cools the air off escapes from the air conditioning system, your air conditioner can no longer cool off the outside air
• Condenser and compressor. These are parts of your AC system that compress and expand a refrigerant gas to cool off the outside air. They are fairly complex.

When you bring your vehicle into our service center, we'll run a series of diagnostic tests to figure out what isn't working correctly.  The air conditioning system has a lot of parts. There are electrical and mechanical components plus a series of hoses and tubes that all can wear out over time.  Any one of these can fail.

A lot of drivers think they have a "Freon leak" and believe that if they get their AC system recharged with the refrigerant, everything will be fine.  But AC systems are so complex, it usually takes a trained technician to accurately figure out where the problems are.

Sometimes the solution is simple.  If your blower motor wears out or there's a fuse that has blown, the technician can replace the bad parts and you'll quickly be back to enjoying your rolling refrigerator. But when compressors or condensers go bad, those are much more involved and expensive to fix.

For instance, electrical problems can sometimes lead to acid to build up and corrode other parts of your AC system.  Sometimes that causes so much damage, your whole air conditioning system has to be replaced. That's why it's always a good idea to have your AC regularly maintained.  Our technicians can find a problem early and prevent more expensive repairs down the road. That's really the cool way to go.

American Brake Centers Inc.
3435 Bashford Ave Ct.
Louisville, KY 40218
502-459-0355
www.americanbrakecenters.biz

The Third Brake Light (Third Brake Light Service)

So you thought you only had two brake lights.  Look again and you'll see one in the center at a higher level than the two on either side of the vehicle.  They're sometimes in the inside of the vehicle behind the back window, or they could be in the deck lid, on the roof or on the spare wheel carrier,

But why is that third brake on your vehicle? Experts say it helps prevent rear end collisions. Tests done by installing the third brake light in taxis and fleet vehicles showed fewer rear end crashes in the ones that had the extra light. The third brake light was mandated in new passenger cars in 1986 in the US and Canada.  The requirement was added to new light trucks and vans in 1994.

Sometimes it's difficult to know if your third brake light is even working.  Many vehicles have bulb warning systems that alert you to non-functional bulbs, but not all do. Your vehicle service facility will often check to see if all your turn signals, taillights and headlights are working during routine maintenance inspections, and they may notice that the third brake light is out. 

So, do you have to have it replaced? Not necessarily. Many areas only require one brake light to work in the rear of a vehicle. So even though new vehicles have to have the third brake light, you may not get a ticket if it eventually stops working.  But you may be missing an opportunity to drive a safer vehicle if you don't get it fixed.

In 1995, an insurance institute study found that 1986 model cars were involved in 5 percent fewer rear-end collisions from 1986-1991 than they would have expected without the extra light.

Ask your service advisor for advice.  Keep in mind that in these days of drivers distracted by everything from texting to putting on makeup while driving, you can reasonably conclude that anything that makes you more visible to the vehicle behind you adds one more—possibly life saving—safety margin. 

American Brake Centers Inc.
3435 Bashford Ave Ct.
Louisville, KY 40218
502-459-0355
www.americanbrakecenters.biz